Yaskawa Sigma II Indexer Bedienungsanleitung PDF herunterladen (Seite 50)

Sigma II Indexer User’s Manual Two-Step Trial Operation

4-5

also appear in red immediately at power-up if an alarm occurs. In this case, turn OFF

power and take appropriate action. See 8 Troubleshooting.

Note If an absolute encoder is used, it must be set up. Refer to 5.6.4 Absolute Encoder Setup.

4. Operate with the Panel Operator.

Operate the servomotor using the Panel Operator. Check to see if the servomotor runs

normally. If using a servomotor with a holding brake, refer to 5.3.3 Using the Holding

Brake.

Jog Mode Operation

a) Press the MODE/SET key to select Fn002 in the auxiliary function mode.

b) Press the DATA/SHIFT key for a minimum of one second to select the Panel

Operator operation mode. Operation is now possible using the panel operator.

c) Press the MODE/SET key to set to the servo ON (with motor power turned

ON).

d) Press the Up Arrow  or Down Arrow  key to operate the motor. The motor

keeps operating while the key is pressed.

e) Press the MODE/SET key to set to the servo OFF state (with motor power

turned OFF). Alternatively, press the DATA/SHIFT key for a minimum of one

second to set to the servo OFF state.

{

SGDM-

MODE/SET DATA/

CHARGE POWER

SERVOPACK

200V

YASKAWA

Motor Forward

Rotation

Motor Reverse

Rotation

Panel operator

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 226 227

Keine Kommentare

Yaskawa Sigma II Indexer Bedienungsanleitung Seite 50