YASKAWA FSP Series Installationsanleitung PDF herunterladen (Seite 42)

FSP Amplifier Short Form Installation Guide Inspection and Maintenance

7.2. Part Replacement Period

The following parts are subject to mechanical wear or deterioration over time.

To avoid failure, rep lace these p arts at the frequency indicated.

If the FSP Amplifier has been repaired at YEA, its p arameters will be set back to

standard settings at shipment. Always check parameters before operating the

servomotor.

Part

Standard

Replacement

Period

Replacement Method

Operating

Conditions

Cooling Fan 4 to 5 years Replace with new part

Smoothing

Capacitor

7 to 8 years

T est. Replace with new part if

necessary.

Relays — T est. Replace if necessary.

Fuse 10 years Replace with new part.

Electrolytic

Capacitor on

Circuit Board

5 years

T est. Replace with new

circuit board if necessary.

• Ambient

temperature:

annual average

30ºC

• Load factor:

80% max.

• Op eration rate:

20 hours/day

max.

7.3. Replacing the Battery for an Absolute Encoder

Battery replacement is only required for servo sy stems using an absolute

encoder. When battery voltage is 2.7 V or less, the FSP Amplifier outputs an

absolute encoder battery alarm (A.83, when using Yaskawa Sigma II motors

with an absolute encoder) only when the FSP Amplifier's power is ON, but not

while the FSP Amplifier is operating.

7.3.1. Recommended Battery

Lithium battery: ER3V, manufactured by Toshiba Battery Co. Ltd.,

3.6 V 1000 mAh or other compatible lithium battery.

Battery kit (battery with connector) for Absolute Encoder Cable Adapter

or wiring into CN1: JZSP-BA01

Battery kit (battery with connector) for wiring into CN1: JZSP-BA01-1

For wiring into CN1, refer to the Sigma FSP Servo System User’s Manual

(Document # YEA-SIA-FSP-3), Absolute Encoder Battery.

Note: The JZSP-BA01-1 has leads 3 cm longer than the JZSP-BA01.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 57 58

Kommentare zu diesen Handbüchern

Keine Kommentare

YASKAWA FSP Series Installationsanleitung Seite 42

Kommentare zu diesen Handbüchern